Three weeks ago I sent a model of a prototype to be printed…
Then I met up with Funkit Toys creator, Kenton, and we made a negative mold and poured some silicone!
We concluded that we hadn’t used enough non-stick spray. My first baby was a failure. Too much of the plug was fused to the mold. But I loved holding it in my hand. We were soooooo close!
So we tried again after fixing the mold a bit and applying extra non-stick spray.
BABY BLUE WAS BORN:
And now the next phase begins…
(Basically, that means trying to make a good model for a 3d printed negative mold that can just be poured into.)